Rolling machine

The machine built-in counter balance is designed for reducing vibration.
The machine is separated lubricating oil for slide movement and processing oil, and environmental friendly structure by reusing lubricating oil with circulating system.
The compact centrifugal separator is equipped in the oil tank portion.Electric set-up device is installed for pitch alignment.
The clamping device is installed for stationary die to make adjustment of drawing the die easily.
The numerical value to show lifting position is indicated on the rail part to shorten change-over work.
The monitor for watching sliding temperature is installed in the slide portion as standard.
The sliding part is equipped with wear resistance metal linner, and cooled with water to reduce temperature.
As Starter Finger is installed with automatic control, the change-over is done easily.
The detector for the defective screws and the ejection chute to take them out automatically are equipped with.
The installation of Parts Feeder(equipment to supply blank) is optionally selected by the customers.

The machine is designed to reduce noise and vibration even in start-up operation.
The newly developed circulating system has environmental friendly structure reusing luricating oil.
The hand wheel with interlock for pitch alignment and hand cutting is equipped with.
The numerical value to show lifting position is indicated on the rail part to shorten change over work.
The monitor for watching sliding temperature is installed in the slide portion as standard.
The sliding part is equipped with cooling device to reduce temperature.
Micrometer type adjustment screw is equipped in adjustment part to draw die as standard.
Starter Finger is installed with automatic control and structured to remove outside. When combined with the detector for the defective screw, they can be more effectively.
The lifting work for Parts Feeder can be done easily with the handle in work side.